# 56MDA16.CFG # # This file contains the configuration for the MVI56-MDA16 communication module. # # LOCATION : Test Bench # DATE : 02/02/2005 # CONFIGURED BY : KDH # MODIFIED : # # This section is used to define the configuration for the Module level # data. # [Module] Module Name : Test Example of MVI56-MDA16 Communication Module # # [Backplane 56] Read Register Start : 0 #Starting register in virtual database to read from the processor Read Register Count : 1600 #Number of registers to read from the processor Write Register Start : 0 #Starting register in virtual database to write to the processor Write Register Count : 0 #Number of registers to write to the processor Backplane Fail Count : 5 #Number of consecutive backplane transfer failures before halting communications Error/Status Block Pointer : 6000 #Start of Status Table Block Transfer Size : 200 #Number of words in block (40/200) # #with the use of 40 words block, use ladder MVI56MDA16_40 #with the use of 200 words block, use ladder MVI56MDA16_200 # # # This section is used to define the port 1 configuration for the MDA16 device # [MDA16 Port 1] Enable : Yes #No=Port Disabled,Yes=Port Enabled Baud Rate : 9600 #Baud rate for port (300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200) Parity : None #N=None,O=Odd,E=Even Data Bits : 8 #7 or 8 data bits for messages Stop Bits : 1 #1 or 2 stop bits for messages RTS On : 0 #Delay after RTS set before message sent (mSec) RTS Off : 1 #Delay after message before RTS dropped (mSec) Use CTS Line : No #Monitor CTS modem line (Y/N) Minimum Response Delay : 0 #Number of mSec to delay before response Poll Timeout : 30000 #Poll time out # This section is used to define the port 2 configuration for the MDA16 device # [MDA16 Port 2] Enable : Yes #No=Port Disabled,Yes=Port Enabled Baud Rate : 9600 #Baud rate for port (300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200) Parity : None #N=None,O=Odd,E=Even Data Bits : 8 #7 or 8 data bits for messages Stop Bits : 1 #1 or 2 stop bits for messages RTS On : 0 #Delay after RTS set before message sent (mSec) RTS Off : 1 #Delay after message before RTS dropped (mSec) Use CTS Line : No #Monitor CTS modem line (Y/N) Minimum Response Delay : 0 #Number of mSec to delay before response Poll Timeout : 30000 #Poll time out