# ConfigEdit Version: 2.0.12 Build 1 # ProSoft Technology [Module] Module Type : PTQ-WA-PWP Module Name : PTQ-WA-PWP [Backplane Configuration] Read Register Start : 0 # DB start location for data received from processor is placed Read Register Count : 1000 # Number of registers to move from processor to module Write Register Start : 1000 # DB start location for data moved from module to processor Write Register Count : 1000 # Number of registers to move from module to processor Failure Flag Count : 0 # 3x Register Start : 11 # 3x start register where data moved from module to processor (1-n) 4x Register Start : 21 # 4x start register where data moved from processor to module (1-n) [Module Comment] # New Firmware. With Multicast, With PWP commands. Test for Program Scan Time=same as with the Old Driver. [RADIO CONFIGURATION] SIGNAL LED 1 : 20 # minimum signal quality level for LED 1 SIGNAL LED 2 : 25 # minimum signal quality level for LED 2 SIGNAL LED 3 : 30 # minimum signal quality level for LED 3 SIGNAL LED 4 : 35 # minimum signal quality level for LED 4 RTS Threshold : 2347 # RTS/CTS handshake threshold byte count (1 to 2347) Transmit Rate : 3 # Will Xmitt at 11, 5.5, 2 or 1 MB WEP Key Rollover : N # [RADIO SNTP CLIENT] NTP SERVER IP ADDRESS : 0.0.0.0 # IP address for NIST, 132.163.4.102 TIME ZONE : 8 # Number of hours from GMT (-11 to +11) USE DAYLIGHT SAVINGS TIME : N # Yes or No DATABASE REGISTER : 3000 # database word location where to store time (-1=ignore). [RADIO PWP EXCHANGES] START # Exch Cast DB Reg Swap P/C IP Addres Exch Config. Sig. Comment # Type Type Reg Coun Cod Time ID Major Minor C M 0 5 0 8000 172.16.10.71 10710 1 0 # # P U 0 5 0 2000 172.16.10.71 10780 1 0 # END [RADIO PWP MULTICAST GROUP LIST] START # IP Addres Comment # 224.0.7.7 # END # NOTE: The Module does not need the Static ARP tables, but it does support them, although at this time PCB des not. #[RADIO STATIC ARP TABLE] #START # 172.16.10.79 00:10:C6:90:9C:26 #END