# N2.CFG (FILE NAME SPECIFIC!!! Must be named N2.CFG when downloaded to the MVI46-N2 module) # # This file contains the configuration for the MVI46-N2 communication module. # # LOCATION : Test Bench # DATE : 11/06/2006 # CONFIGURED BY : KDH # MODIFIED : # # This section is used to define the configuration for the Module level # data. # [Module] Module Name : Test Example of MVI46-N2 Communication Module # # [Backplane 46] Backplane Fail Count : 10 #Number of consecutive backplane transfer failures before halting communications # # # This section is used to define the N2 configuration data. # [N2 Config] Binary Input Object Count : 16 #Determines the number of Binary Input Objects available (0 - 960) Analog Input Object Count : 16 #Determines the number of Anaolg Input Objects available (0 - 300) Binary Output Object Count : 16 #Determines the number of Binary Output Objects available (0 - 960) Analog Output Object Count : 16 #Determines the number of Analog Output Objects available (0 - 300) # # # This section is used to define the port 1 configuration for the N2 device # [N2 Port 1] Enable : Yes #No=Port Disabled,Yes=Port Enabled Slave Address : 1 #0-255 N2 Slave Node Address Baud Rate : 9600 #Baud rate for port (300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200) Parity : None #N=None,O=Odd,E=Even Data Bits : 8 #7 or 8 data bits for messages Stop Bits : 1 #1 or 2 stop bits for messages RTS On : 0 #Delay after RTS set before message sent (mSec) RTS Off : 1 #Delay after message before RTS dropped (mSec) Minimum Response Delay : 50 #Number of mSec to delay before response Use CTS Line : No #Monitor CTS modem line (Y/N) # This section is used to define the port 2 configuration for the N2 device # [N2 Port 2] Enable : Yes #No=Port Disabled,Yes=Port Enabled Slave Address : 1 #0-255 N2 Slave Node Address Baud Rate : 9600 #Baud rate for port (300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200) Parity : None #N=None,O=Odd,E=Even Data Bits : 8 #7 or 8 data bits for messages Stop Bits : 1 #1 or 2 stop bits for messages RTS On : 0 #Delay after RTS set before message sent (mSec) RTS Off : 1 #Delay after message before RTS dropped (mSec) Minimum Response Delay : 0 #Number of mSec to delay before response Use CTS Line : No #Monitor CTS modem line (Y/N)