KB Home \| Advanced Search \| News \| Ask Question
ProSoft Knowledge Base

How do I completely remove a ProSoft Add-On Instruction (AOI) from an RSLogix5000 project?

Article Number: 472 | Rating: 5/5 from 1 votes | Last Updated: Wed, Aug 31, 2016 at 10:01 PM

When a ProSoft AOI is initially installed, the User-Defined Data Types (UDT's), controller tags, and AOI logic is imported into the existing program. You will need to remove these in a certain order:

1. Delete the ProSoft card from the I/O configuration in Slot X.

2. Delete the ProSoft AOI rung from the logic.

3. In the Controller Tags, click on the bottom tab 'Edit Tags'. Delete the tags that were imported when this module was created. (AOIxxMCM, MCM, etc)

4. Delete the ProSoft Add-On Instruction object from the project tree under the 'Add-On Instructions' on the left side of the RSLogix5000 program

5. Delete the ProSoft UDTs in order. To identify the ProSoft UDTs, look for the UDTs with the part number as part of it's name. For instance: MCMDATA or MNETStatus. Some UDTs are dependent on others. If you cannot delete a UDT, continue to delete all of the ones that RSLogix will allow you to delete, then start back at the bottom of the list, and attempt to delete the ones you were not able to delete before. This will allow you delete ALL of the UDT's. Do not attempt to import another AOI until you have fully removed all of the UDT's. If you have any problems, contact the Technical Support Department for additional help.

This is a general overview of removing a ProSoft AOI. There may be additional steps needed.

Custom Fields

Attachments (0)

There are no attachments for this article.

Comments

There are no comments for this article. Be the first to post a comment.

Does the ladder logic or Add-On Instruction for my InRAx module need to be installed in order to access the Debug Menu?

Viewed 1 times since Tue, Nov 28, 2006

Are any ProSoft solutions SIL2 rated?

Viewed 1 times since Tue, Oct 14, 2008

Array Subscript too Large Controller Fault

Viewed 1 times since Mon, Jan 18, 2016

I cannot locate the .EDS file for my ProSoft Product. Where can I get the proper .EDS file for my module?

Viewed 1 times since Thu, May 5, 2016