ProSoft Knowledge Base - Related Articles http://www.prosoft-technology.com/kb/article.php?id=357 This RSS Feed contains Related Articles of the knowledge base. You can click on the title to view its content. Powered by PHPKB Knowledge Base Script (http://www.knowledgebase-script.com) http://www.prosoft-technology.com/kb/article.php?id=14 What Modbus address would we need to put into the MODSIM32 simulator if we specified on the MVI56-MCM device address to 8680HEX (-31104 decimal) when the MVI56-mcm is the slave? http://www.prosoft-technology.com/kb/article.php?id=14 http://www.prosoft-technology.com/kb/article.php?id=295 How can I detect the feedback status of individual command successful or failed? http://www.prosoft-technology.com/kb/article.php?id=295 http://www.prosoft-technology.com/kb/article.php?id=382 What's the difference between Modbus ASCII and Modbus RTU? http://www.prosoft-technology.com/kb/article.php?id=382 http://www.prosoft-technology.com/kb/article.php?id=289 How do I read/write Modbus binary data? http://www.prosoft-technology.com/kb/article.php?id=289 http://www.prosoft-technology.com/kb/article.php?id=378 I have a ProSoft Modbus Master solution and would like to know, is the Slave Status List the best place to monitor for communications health of the network? http://www.prosoft-technology.com/kb/article.php?id=378 http://www.prosoft-technology.com/kb/article.php?id=55 How do I enter a Modbus address of 40001 or higher in the DevAddress command field of my MVI56-MCM? http://www.prosoft-technology.com/kb/article.php?id=55 http://www.prosoft-technology.com/kb/article.php?id=56 Why is the bit or coil level data incorrect? http://www.prosoft-technology.com/kb/article.php?id=56 http://www.prosoft-technology.com/kb/article.php?id=151 How can a module's Modbus port, configured as a Slave port, detect communication loss with the Master port? http://www.prosoft-technology.com/kb/article.php?id=151 http://www.prosoft-technology.com/kb/article.php?id=443 What are the causes of a -11 error code using a ProSoft Modbus product? http://www.prosoft-technology.com/kb/article.php?id=443 http://www.prosoft-technology.com/kb/article.php?id=564 Why are my PLX gateway modbus serial commands not executing despite being enabled? http://www.prosoft-technology.com/kb/article.php?id=564