ProSoft Knowledge Base - Related Articles http://www.prosoft-technology.com/kb/article.php?id=47 This RSS Feed contains Related Articles of the knowledge base. You can click on the title to view its content. Powered by PHPKB Knowledge Base Script (http://www.knowledgebase-script.com) http://www.prosoft-technology.com/kb/article.php?id=289 How do I read/write Modbus binary data? http://www.prosoft-technology.com/kb/article.php?id=289 http://www.prosoft-technology.com/kb/article.php?id=561 My RX light is on solid, what might that indicate? http://www.prosoft-technology.com/kb/article.php?id=561 http://www.prosoft-technology.com/kb/article.php?id=189 I have limited or no experience with Modbus. How can I find out more about the protocol and command structure? http://www.prosoft-technology.com/kb/article.php?id=189 http://www.prosoft-technology.com/kb/article.php?id=357 Read Commands from my Modbus Master to a ProSoft MCM Slave are working but Write Commands are failing. How do I fix this? http://www.prosoft-technology.com/kb/article.php?id=357 http://www.prosoft-technology.com/kb/article.php?id=564 Why are my PLX gateway modbus serial commands not executing despite being enabled? http://www.prosoft-technology.com/kb/article.php?id=564 http://www.prosoft-technology.com/kb/article.php?id=166 Can Modbus support redundant masters? http://www.prosoft-technology.com/kb/article.php?id=166 http://www.prosoft-technology.com/kb/article.php?id=56 Why is the bit or coil level data incorrect? http://www.prosoft-technology.com/kb/article.php?id=56 http://www.prosoft-technology.com/kb/article.php?id=14 What Modbus address would we need to put into the MODSIM32 simulator if we specified on the MVI56-MCM device address to 8680HEX (-31104 decimal) when the MVI56-mcm is the slave? http://www.prosoft-technology.com/kb/article.php?id=14 http://www.prosoft-technology.com/kb/article.php?id=391 I am trying to use a ProSoft Modbus solution to send/receive data to a MSA Ultima X gas dectection system with Modbus interface and am having problems. How can I resolve this issue? http://www.prosoft-technology.com/kb/article.php?id=391 http://www.prosoft-technology.com/kb/article.php?id=443 What are the causes of a -11 error code using a ProSoft Modbus product? http://www.prosoft-technology.com/kb/article.php?id=443