Honeywell 7800 Communications Module

3150-CBM

The ProSoft 3150-CBM Honeywell 7800 Series Master Module is designed to allow A-B SLC platforms to interface with Honeywell 7800 Series Burner Management hardware devices.

The 3150-CBM module acts as a polling master over the Honeywell 7800 Series of burner management products. Through simple ladder logic and data table configuration, an SLC ladder application is able to access important operational data from the 7800 units for display in the data table. In addition, the ladder is able to write to points in the slave devices.

Features

Simple to Use

All module setup and operating control is performed over the backplane through simple ladder logic and data table configuration. The only software needed is a ladder-programming package.

Hands Off Operation

Once the CBM module has been setup for operation, the card is capable of accessing (read/write) the points in the burner management devices. The CBM module is integrated directly into the SLC rack, forming a tightly integrated and practical solution. Once configured, the module will perform all protocol related functions as commanded by the ladder logic program.

Installation, Set Up and Operation

The ProSoft module installs in any slot in a local rack (or a remote rack in the case of the 3100 module). The product's capabilities are enabled and controlled with simple ladder logic and data table initialization.

Applications

The Honeywell 7800 Master module can be found in many industrial sectors, including manufacturing.

Functional Specifications

• Two fully configurable serial ports - each capable of supporting the CBM Master functionality using the ASCII mode of communications
• RS-485 connection from each port directly to Honeywell QS7850A interface modules
• Supports up to 32 Honeywell nodes per serial port
• Supports polling of rpa command accessible data using the integer data type
• Floating point values are scaled x 10 by module
• ASCII text strings are not supported
• Supports one-shoted writes using to wpa/wpqa accessible data from ladder logic
• Up to 40 'device config files' are available for user configuration
• Communication configuration (from processor ladder logic)
  - Node addr - 8 to 255
  - Baud rate - 300 TO 38,400
  - Parity - none (fixed
  - Stop bit - 1 (fixed)
  - RTS to TxD - 50 ms (fixed)
  - Timeout - 4 seconds (fixed)
  - Mode - ASCII (fixed)

• Supported CBM command codes
  - rpa - read point
  - pqa - read point qualified
  - wpa - write point
  - wpqa - write point qualified
  - sn-set address

• Error codes returned to the ladder processor along with a poll execute toggle bit

Hardware Specifications

• Backplane current load
• 3150 module for SLC
  - 5V @ 0.15 A
  - 24 V @ 0.040 A

• Operating temperature
  - From 0° C to 60° C (32° F to 140° F)

• Storage temperature
  -From -40° C to 85° C (-40° F to 185° F)

• Relative humidity
  - From 5% to 95% (without condensation)

• LED indicators
  - Module Status
  - Backplane transfer status
  - Serial port TX/RX activity LED
  - Serial port error LED status

• Application Serial ports
  - DB-25F - 3100 module
  - DB-9M - 3150 module
  - RS232/422/485 jumper selectable
  - RS422/485 screw termination included (two per module)
  - RS-232 hardware handshaking (RTS/CTS, DTR)
  - 500 V Optical isolation from backplane

Ordering Information

Distributors:
Place your order by email to orders@prosoft-technology.com:, fax to +1 661-716-5101.

Sales and Support: