IEC 61850 Client for ControlLogix®
What do you need help with?
I need to set up a ProSoft PROFIBUS Master to talk to a Siemens S7-300 series CPU that is set up as a PROFIBUS Slave. How do I do that?
The attached file shows how to set up a S7-315 CPU to be a PROFIBUS DP Slave to a ProSoft MVI56-PDPMV1 PROFIBUS Master and was written for that specific application. However, many of the setup steps
Read moreWhat are the advantages of the MVI46-MCM compare to the 3150-MCM?
Here are some of the main advantages of the MVI46-MCM over the 3150-MCM: Direct M0/M1 file access, makes it much easier to configure You do not need to page memory as the 3150-MCM supports
Read moreMy MVI46 module faults the processor after cycling power to the rack.
will automatically update any M1/M0 slot references in the logic as you drag the MVI module from one slot to another in the I/O configuration.
Read moreCan my ProSoft or ProLinx DFCM module communicate through an Allen-Bradley 1747-AIC module?
The 1747-AIC module only converts the signal from RS-485 to RS-232. It does not convert the protocol from DH-485 to DF1, which the DFCM module requires. For DH-485 communications, check the ProSoft
Read moreWhat do I do if I suspect that my MVI56-PDPMV1 master GSD file is corrupted?
If you are experiencing difficulty with the MVI56-PDPMV1 master configuration, you may have a corrupted GSD file. This can happen if you have up-graded your copy of Prosoft Configuration Builder ... MVI56-PDPMV1, PROFIBUS ... What do I do if I suspect that my MVI56-PDPMV1 master GSD file is corrupted?
Read more