Home » Categories » Protocols » DH-485

Is the MVI56-DH485 card a gateway module for the ControlLogix platform?

The MVI56-DH485 module was designed for data transfer between a DH-485 network and a ControlLogix processor. This modules requires the use of a ControlLogix processor and will not act as a gateway device like a 1756-ENET, 1756-CNB, or 1756-DHRIO module.

Once the data is in the ControlLogix processor, this data can then be sent out on your various networks(Ethernet, ControlNet, DH+, etc) but the module must communicate with the processor.

Programming of the DH-485 devices is not supported through the MVI56-DH485 module, and a Rockwell AIC converter is recommended.

Custom Fields
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Related Articles RSS Feed
    There are no related articles for this article.