I have a xxxx-xxx-DFCM4 with Pass-Through enabled. The Pass-Through (Debug/CFG) port and the Port 0 DFCM port shows no activity. What am I doing wrong?
When using a ProLinx gateway that supports DF1 pass-through, you will
need to enable at least one command on DFCM port 0. If no commands are really needed, than the poll rate on a single command can be set to a high poll rate in order to minimize the impact.
Article ID: 135
Created On: Tue, Nov 28, 2006 at 11:10 AM
Last Updated On: Mon, Jun 30, 2014 at 3:34 PM
Authored by: Technical Support