To access 32 bit data types in Rockwell Automation controllers it will be necessary to use the COP or CPS instruction to copy the value into the appropriate data type.
(The Length parameter in these instructions are based upon the destination tag's data type.)
Note: Since two consecutive registers are required to store each 32 bit value in the internal database, it is important to remember that the next available value is not (Starting Internal Address +1), but rather (Starting Internal Address + 2) so that all 32 bit values will begin on either an odd number or an even number.
Article ID: 288
Created On: Wed, Nov 29, 2006 at 8:42 AM
Last Updated On: Wed, Jun 8, 2016 at 7:03 PM
Authored by: Technical Support
Online URL: https://www.prosoft-technology.com/kb/article.php?id=288