What is the default addressing schema for the EtherNet IP DCSNet(2) Slave interface?
When using the DCSNet(2) firmware in a slave configuration the addresses use the following layout:
Drop 0 = N100:0 - N100:63
Drop 1 = N101:0 - N101:63
Drop 2 = N102:0 - N102:63
etc....
The first 32 registers (0 - 31) contains the data that will be sent to the AutoMax controller, and the second 32 registers (32 - 63) contains the data coming from the AutoMax controller.
Article ID: 534
Created On: Wed, Dec 31, 2014 at 2:15 PM
Last Updated On: Wed, Dec 31, 2014 at 2:15 PM
Authored by: Administrator