Is it possible for a FactoryTalk View application to get data from a DCSNet(2) AN-X-AMX Slave?
Yes,
To do so create an ethernet device by right clicking on EtherNet:
Browse the NET ENI folder
Browse the PLC5 Folder
Select the 2nd PLC5 in the list which is the PLC5 L40C
When prompted enter the IP Address of the AN-X-AMX gateway
Map your Shortcut to this device
Click verify
Click the copy from design time to run time button.
Article ID: 535
Created On: Wed, Dec 31, 2014 at 2:26 PM
Last Updated On: Wed, Dec 31, 2014 at 2:26 PM
Authored by: Administrator