A conditional command is useful when the same value does not need to be written to the end device continuously, but rather on change.
A conditional write command is scanned based upon its poll rate (like all other commands). The difference is that it will not be executed unless any of the write data associated with the command has changed. For example, if the starting address is 0, and the count is 10 for the command, if any value within registers 0 - 9 changes, the command will be issued.
The command will be issued once when a change in data is detected, unless a failure occurs. If a failure occurs than it will retry according to the retry count parameter configuration.
Article ID: 90
Created On: Tue, Nov 28, 2006 at 10:27 AM
Last Updated On: Thu, Jul 17, 2014 at 5:34 PM
Authored by: Technical Support
Online URL: https://www.prosoft-technology.com/kb/article.php?id=90