ProSoft Knowledge Base - Related Articles https://www.prosoft-technology.com/kb/article.php?id=351 This RSS Feed contains Related Articles of the knowledge base. You can click on the title to view its content. Powered by PHPKB Knowledge Base Script (http://www.knowledgebase-script.com) https://www.prosoft-technology.com/kb/article.php?id=268 After I install and open ControlScape and open the app, I get an error that says "Serial Port Control Create Failed". https://www.prosoft-technology.com/kb/article.php?id=268 https://www.prosoft-technology.com/kb/article.php?id=6 Debug port connection parameters for Prosoft modules and gateways https://www.prosoft-technology.com/kb/article.php?id=6 https://www.prosoft-technology.com/kb/article.php?id=182 Apparent data corruption in 33 words of MVI56-MCM or MVI56E-MCM ReadData or WriteData arrays. https://www.prosoft-technology.com/kb/article.php?id=182 https://www.prosoft-technology.com/kb/article.php?id=162 I was not using both Modbus ports on my MVI56-MCM module, so I set all the port parameters for the unused port to zeros to disable the port and now my module is faulted and will not restart. Why? https://www.prosoft-technology.com/kb/article.php?id=162 https://www.prosoft-technology.com/kb/article.php?id=307 What is the difference between your MVI56E-MCM and MVI56E-MCMR modules? https://www.prosoft-technology.com/kb/article.php?id=307 https://www.prosoft-technology.com/kb/article.php?id=177 Where are the on-board jumper positions defined for my MVI module? https://www.prosoft-technology.com/kb/article.php?id=177 https://www.prosoft-technology.com/kb/article.php?id=559 Differences between the PLX31 & PLX32 Gateways https://www.prosoft-technology.com/kb/article.php?id=559 https://www.prosoft-technology.com/kb/article.php?id=135 I have a xxxx-xxx-DFCM4 with Pass-Through enabled. The Pass-Through (Debug/CFG) port and the Port 0 DFCM port shows no activity. What am I doing wrong? https://www.prosoft-technology.com/kb/article.php?id=135 https://www.prosoft-technology.com/kb/article.php?id=168 My 3150-MCM block IDs are incrementing until I connect the communications cable. Once the cable is connected, the block ID stops incrementing. https://www.prosoft-technology.com/kb/article.php?id=168 https://www.prosoft-technology.com/kb/article.php?id=190 Why does the session time out when downloading a configuration file via HyperTerminal to my 4xxx or 5xxx Series ProLinx Gateway? https://www.prosoft-technology.com/kb/article.php?id=190