ProSoft Knowledge Base - Related Articles https://www.prosoft-technology.com/kb/article.php?id=564 This RSS Feed contains Related Articles of the knowledge base. You can click on the title to view its content. Powered by PHPKB Knowledge Base Script (http://www.knowledgebase-script.com) https://www.prosoft-technology.com/kb/article.php?id=556 Configuration Storage on the PLX31 & PLX32 Gateways https://www.prosoft-technology.com/kb/article.php?id=556 https://www.prosoft-technology.com/kb/article.php?id=378 I have a ProSoft Modbus Master solution and would like to know, is the Slave Status List the best place to monitor for communications health of the network? https://www.prosoft-technology.com/kb/article.php?id=378 https://www.prosoft-technology.com/kb/article.php?id=55 How do I enter a Modbus address of 40001 or higher in the DevAddress command field of my MVI56-MCM? https://www.prosoft-technology.com/kb/article.php?id=55 https://www.prosoft-technology.com/kb/article.php?id=56 Why is the bit or coil level data incorrect? https://www.prosoft-technology.com/kb/article.php?id=56 https://www.prosoft-technology.com/kb/article.php?id=443 What are the causes of a -11 error code using a ProSoft Modbus product? https://www.prosoft-technology.com/kb/article.php?id=443 https://www.prosoft-technology.com/kb/article.php?id=68 Defining the Slave ID when issuing Modbus Broadcast write commands https://www.prosoft-technology.com/kb/article.php?id=68 https://www.prosoft-technology.com/kb/article.php?id=288 How do I get Floating Point (or Double INT or Unsigned INT) data? https://www.prosoft-technology.com/kb/article.php?id=288 https://www.prosoft-technology.com/kb/article.php?id=530 How does the gateway know where to load or store configuration files (SD card or non-volatile RAM)? https://www.prosoft-technology.com/kb/article.php?id=530 https://www.prosoft-technology.com/kb/article.php?id=351 Which of your products support RS-485 serial protocols? https://www.prosoft-technology.com/kb/article.php?id=351 https://www.prosoft-technology.com/kb/article.php?id=14 What Modbus address would we need to put into the MODSIM32 simulator if we specified on the MVI56-MCM device address to 8680HEX (-31104 decimal) when the MVI56-mcm is the slave? https://www.prosoft-technology.com/kb/article.php?id=14