KB Home \| Advanced Search \| News \| Ask Question
ProSoft Knowledge Base

If I am reading the value from ProSoft 4x register, and it represents a digital input or digital output, how is the value stored?

Article Number: 47 | Rating: Unrated | Last Updated: Fri, Jan 18, 2008 at 12:00 AM

Each digital point coming from the drive will be placed in an integer register in the ProSoft module. So a digital 0 will be an analog 0 (0x00), and a digital 1 will be an analog 1 (0x01).

Custom Fields

Attachments (0)

There are no attachments for this article.

Comments

There are no comments for this article. Be the first to post a comment.

How can a module's Modbus port, configured as a Slave port, detect communication loss with the Master port?

Viewed 1 times since Tue, Nov 28, 2006

I have limited or no experience with Modbus. How can I find out more about the protocol and command structure?

Viewed 1 times since Tue, Nov 28, 2006

Why are my PLX gateway modbus serial commands not executing despite being enabled?

Viewed 1 times since Wed, Aug 12, 2015

Defining the Slave ID when issuing Modbus Broadcast write commands

Viewed 1 times since Tue, Nov 28, 2006

How can I detect the feedback status of individual command successful or failed?

Viewed 1 times since Wed, Nov 29, 2006

I have multiple Modbus masters that need to communicate with 1 or more Modbus serial (RTU) slave devices. What product should be used??

Viewed 1 times since Tue, Jan 23, 2007

How do I monitor the health of coms to my slaves when the module is a Master?

Viewed 1 times since Wed, Nov 29, 2006

What are the causes of a -11 error code using a ProSoft Modbus product?

Viewed 1 times since Mon, May 17, 2010

Do any Prosoft modules support Modbus UDP?

Viewed 1 times since Mon, Aug 24, 2015

My RX light is on solid, what might that indicate?

Viewed 1 times since Fri, Jul 17, 2015