Home » Categories » Multiple Categories |
Which ProSoft products can communicate with a Honeywell DCS System? |
Article Number: 345 | Rating: 4/5 from 1 votes | Last Updated: Thu, Jul 3, 2014 at 10:29 PM |
Most Honeywell DCS Systems support either Serial Modbus or Modbus TCP communication. If your application involves Rockwell Automation PACs or PLCs than consider one of our In-Chassis modules such as the MVI56E-MCM or the MVI56E-MNET. If the application is using another PLC or PAC than a gateway solution is more practical. Please use the gateway product selector to find the best solution, or call your Regional Technical Support Center. |
Attachments (0)
There are no attachments for this article.
|
Comments
There are no comments for this article. Be the first to post a comment.
|
What is Enron-Daniels mode?
Viewed 1 times since Thu, May 5, 2016
How do I fix the Arithmetic Overflow Error
Viewed 1 times since Tue, Jun 16, 2015
Why am I getting: Download was successful but Module failed to reboot in 60 seconds
Viewed 1 times since Thu, Apr 14, 2016
Which of your products support RS-485 serial protocols?
Viewed 1 times since Wed, Feb 6, 2008
Where are the on-board jumper positions defined for my MVI module?
Viewed 1 times since Tue, Nov 28, 2006
What does a -36 modbus error code indicate?
Viewed 1 times since Thu, Aug 20, 2015
When I increase the ReadData or WriteData array sizes in my program, all of the configuration parameter values go to 0.
Viewed 1 times since Tue, Nov 28, 2006
Apparent data corruption in 33 words of MVI56-MCM or MVI56E-MCM ReadData or WriteData arrays.
Viewed 1 times since Tue, Nov 28, 2006
What causes a conditional command to be issued?
Viewed 1 times since Tue, Nov 28, 2006
What is the purpose of the UseGuardBand/GuardBandTime or InterCharacterDelay parameters in an MCM module?
Viewed 1 times since Tue, Nov 28, 2006
|