KB Home \| Advanced Search \| News \| Ask Question
ProSoft Knowledge Base

Can my ProSoft or ProLinx DFCM module communicate through an Allen-Bradley 1747-AIC module?

Article Number: 38 | Rating: Unrated | Last Updated: Fri, Jan 18, 2008 at 12:00 AM

The 1747-AIC module only converts the signal from RS-485 to RS-232. It does not convert the protocol from DH-485 to DF1, which the DFCM module requires. For DH-485 communications, check the ProSoft website for modules which support DH-485.

Custom Fields

Attachments (0)

There are no attachments for this article.

Comments

There are no comments for this article. Be the first to post a comment.

Why am I unable to communicate with Wonderware from a 4xxx or 5xxx Series gateway in a full Duplex DF1 configuration

Viewed 1 times since Tue, Nov 28, 2006

What product can be used to connect more than one DF1 master device to one or more DF1 slave devices?

Viewed 1 times since Tue, Nov 28, 2006

I am using a ProSoft DFCM solution (or possibly another DF1 protocol product) and I am having problems establishing and/or maintaining communications with a node that his been assigned Station Number

Viewed 1 times since Fri, Oct 10, 2008

Is there a limit, in a DF1 message, of the number of registers requested or written in 1 command?

Viewed 1 times since Tue, Nov 28, 2006

What does an error code of -200 (0xFF38) represent in my DFCM module?

Viewed 1 times since Tue, Nov 28, 2006