Home » Categories » Protocols » Modbus

I am trying to use a ProSoft Modbus solution to send/receive data to a MSA Ultima X gas dectection system with Modbus interface and am having problems. How can I resolve this issue?
Article Number: 391 | Rating: 2/5 from 5 votes | Last Updated: Wed, Mar 9, 2011 at 2:38 PM

The MSA UltimaX gas detectors have a Modbus interface implementation that is within the limits of the Modbus protocol specifications but is somewhat different than more conventional Modbus communications implementations by other manufacturers.  Therefore, how you access data from the MSA UltimaX systems may seem a little odd, at first.

The User Manual provided by MSA does a good job of describing how they implement the Modbus protocol and how to address data registers within their system.  Please refer to their documentation for additional details.
Custom Fields
    Posted by: Administrator - Thu, Apr 24, 2008 at 12:42 PM This article has been viewed 23248 times.
    Filed Under: Modbus
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Icon Add Comment
    Name
    Email (Required, but not published)
    Comment
    Security Code Security Code
     
    Related Articles RSS Feed
    Do any Prosoft modules support Modbus UDP?
    Viewed 1 times since Mon, Aug 24, 2015
    What Modbus address would we need to put into the MODSIM32 simulator if we specified on the MVI56-MCM device address to 8680HEX (-31104 decimal) when the MVI56-mcm is the slave?
    Viewed 1 times since Tue, Nov 28, 2006
    My RX light is on solid, what might that indicate?
    Viewed 1 times since Fri, Jul 17, 2015
    Defining the Slave ID when issuing Modbus Broadcast write commands
    Viewed 1 times since Tue, Nov 28, 2006
    Why is the bit or coil level data incorrect?
    Viewed 1 times since Tue, Nov 28, 2006
    If I am reading the value from ProSoft 4x register, and it represents a digital input or digital output, how is the value stored?
    Viewed 1 times since Tue, Nov 28, 2006
    How do I monitor the health of coms to my slaves when the module is a Master?
    Viewed 1 times since Wed, Nov 29, 2006
    How do you detect the individual Slave failure?
    Viewed 1 times since Wed, Nov 29, 2006
    How do I read/write Modbus binary data?
    Viewed 1 times since Wed, Nov 29, 2006
    How can a module's Modbus port, configured as a Slave port, detect communication loss with the Master port?
    Viewed 1 times since Tue, Nov 28, 2006
    • Icon SubscriberSubscribe to Article
    • Icon PrinterPrint Article
    • Icon EmailEmail Article to Friend
    • Icon PDFExport to PDF
    • Icon MS-WordExport to MS Word
    • Icon TwitterTweet This Article
    • Icon DiggDigg It
    • Icon StumbleuponStumble Upon
    • Icon de.icio.usDel.icio.us
    Article Rating (5 Votes)
    Rate this article
    Powered by PHPKB Knowledge Base Software