Home » Categories » Rockwell In-chassis » PLC » 2100-AGA

What are the 2100-AGA Bios settings on the old hardware that has a VGA port, PCMCIA card, and 3 serial ports?
Article Number: 442 | Rating: Unrated | Last Updated: Wed, Jul 2, 2014 at 3:05 PM
That hardware was the EIP version of the 2100-AGA hardware.  This module required the bios settings listed in the attached document.  That hardware was later replaced by the 2100-AGA rev 3 module, using the same hardware as our MVI71 products. 
The attached BIOS settings are required for the module to work properly. 
Custom Fields
    Posted by: Administrator - Fri, May 7, 2010 at 12:10 PM This article has been viewed 2507 times.
    Filed Under: 2100-AGA
    Attachments (1) Attachments
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Icon Add Comment
    Name
    Email (Required, but not published)
    Comment
    Security Code Security Code
     
    Related Articles RSS Feed
    I have replaced my old 2100-AGA with PCMCIA Flash Card Slot with the newer style 2100-AGA with Compact Flash. Is there a way to edit the Modbus commands stored on the CF card without removing it from
    Viewed 1 times since Wed, Mar 19, 2008
    When my 2100-AGA is configured as a Modbus Master, the request packets being issued by the module are incorrect.
    Viewed 1 times since Tue, Nov 28, 2006
    Can the module of MVI46-MCM be placed in Remote I/O Rack?
    Viewed 1 times since Tue, Nov 28, 2006
    Can an MVI71-AFC or a 2100AGA module to work in a remote rack?
    Viewed 1 times since Tue, Nov 28, 2006
    • Icon SubscriberSubscribe to Article
    • Icon PrinterPrint Article
    • Icon EmailEmail Article to Friend
    • Icon PDFExport to PDF
    • Icon MS-WordExport to MS Word
    • Icon TwitterTweet This Article
    • Icon DiggDigg It
    • Icon StumbleuponStumble Upon
    • Icon de.icio.usDel.icio.us
    Article Rating (No Votes)
    Rate this article
    Powered by PHPKB Knowledge Base Software