KB Home \| Advanced Search \| News \| Ask Question
ProSoft Knowledge Base

What Ethernet ports are required for Prosoft PLC modules and gateways?

Article Number: 510 | Rating: 4/5 from 2 votes | Last Updated: Wed, Nov 25, 2015 at 8:07 PM

Prosoft gateways and in-chassis PLC modules which are configured via Ethernet use UDP port 50000 for discovery and UDP port 3000 for configuration and online diagnostics.

Web based services for products including AN-X2 and Fieldserver gateways require TCP port 80

Some of the more common ports required for application protocols are:

TCP 502 Modbus TCP - MBTCP, MNET products

TCP 44818 Ethernet/IP - EIP and DFNT products

UDP 44818 Ethernet/IP - EIP and DFNT products

TCP 2222 Allen Bradley CSP protocol - Fieldserver

TCP 2000 Encapulated Modbus TCP - Typically used for Modbus TCP through serial to Ethernet media converters with MBTCP and MNET products.

TCP 20000 DNP3 over Ethernet - DNPNET, DNPSNET products

UDP 20000 DNP3 over Ethernet - DNPNET, DNPSNET products

UDP 47808 BACNET IP - Slotserver and Fieldserver BACNET products

UDP 1024 Fieldserver discovery service - Slotserver and Fieldserver products

UDP 18246 GE Ethernet Global Data - All EGD modules and gateways. Note that EGD exchanges may be unicast, multicast, or broadcast

Custom Fields

Attachments (0)

There are no attachments for this article.

Comments

There are no comments for this article. Be the first to post a comment.

What is the bits-per-second (bps) speed of ProSoft Ethernet solutions?

Viewed 1 times since Wed, Dec 3, 2008

Do ProSoft ethernet products support the SNMP protocol?

Viewed 1 times since Tue, Nov 28, 2006

What ProSoft Ethenet Protocols offer UDP support?

Viewed 1 times since Tue, Nov 28, 2006