Home » Categories » Gateways » AN-X2

How to figure out what the IP Address of an AN-X2 gateway is?

There are 2 ways to determine the current IP Address of an AN-X2 gateway.
  • If AnxInit is installed on the PC, then AN-X2 modules will respond to the locate all query that can be found under the Utilities menu. (Note: AnxInit is not able to configure the IP Address of an AN-X2 gateway)

  • Power down the AN-X2 gateway and carefully remove the mSD card from the back of the unit. Then install the mSD card into the SD card adapter and place that into a computer (if prompted to fix the mSD card select Continue without scanning). In the root of the mSD card find a file named Config.txt. This file will show the current IP configuration.
Custom Fields
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Related Articles RSS Feed
    What is the default IP Address of an AN-X2 gateway?
    Viewed 1 times since Wed, Jun 18, 2014
    Which firmware should I use for a DH+ PLC to an EtherNet/IP HMI
    Viewed 1 times since Wed, Feb 24, 2016
    What does the mSD card do on the AN-X2 platform?
    Viewed 1 times since Tue, Jul 29, 2014
    My AN-X2-AB-DHRIO Web GUI is missing the Automation Network tab
    Viewed 1 times since Tue, Aug 25, 2015
    Do AN-X2-AB-DHRIO work with redundant control logix processors?
    Viewed 1 times since Mon, Aug 24, 2015