| Home » Categories » Multiple Categories |
Do AN-X2-AB-DHRIO work with redundant control logix processors? |
| Article Number: 569 | Rating: Unrated | Last Updated: Tue, Nov 3, 2015 at 7:51 PM |
| Yes, AN-X2-AB-DHRIO are capable of communicating via EtherNet/IP with a control logix system that had redundant processors. |
Attachments (0)
There are no attachments for this article.
|
Comments
There are no comments for this article. Be the first to post a comment.
 Add Comment |
Related Articles 
How can I use an AN-X2-AB-DHRIO to allow a SLC5/04 on DH+ to talk to a Panel View Plus on EtherNet/IP
Viewed 1 times since Fri, Aug 28, 2015
How to figure out what the IP Address of an AN-X2 gateway is?
Viewed 1 times since Mon, Sep 29, 2014
Does the AN-X(2) Remote I/O Scanner support Block Transfers?
Viewed 1 times since Thu, Jun 19, 2014
Does the AN-X(2)-AB-DHRIO gateway running the RIO HMI firmware support multiple block transfers to the same Rack, Group, and Slot?
Viewed 1 times since Tue, Aug 5, 2014
Which firmware should I use for a DH+ PLC to an EtherNet/IP HMI
Viewed 1 times since Wed, Feb 24, 2016
Can an AN-X2-AB-DHRIO communicate with a 1756-DHRIO
Viewed 1 times since Tue, Sep 29, 2015
What are common things that prevent reliable DH+ communications on the AN-X(2)-AB-DHRIO gateway running the DH+ Bridge FW?
Viewed 1 times since Wed, Dec 31, 2014
How to control BTRs and BTWs programatically in RSLogix5000 to an AN-X(2) Remote I/O Scanner
Viewed 1 times since Thu, Jun 19, 2014
ControlLogix, CompactLogix, and SLC Message Samples through the AN-X(2) DH+ gateway
Viewed 1 times since Thu, Jun 19, 2014
How do I configure an AN-X(2) Remote I/O Scanner?
Viewed 1 times since Thu, Jun 19, 2014
|
| KB Home | Advanced Search | News | Ask Question |
|
| ProSoft Knowledge Base |  |
|
|
|
Subscribe to Article
Print Article
Email Article to Friend
Export to PDF
Export to MS Word
Tweet This Article
Digg It
Stumble Upon
Del.icio.us