| KB Home | Advanced Search | News | Ask Question |
|
| ProSoft Knowledge Base | |
Category Articles 
What is the default IP Address of an AN-X2 gateway?
Viewed 1 times since Wed, Jun 18, 2014
The default IP Address is 169.254.42.84 Read More
Do AN-X2-AB-DHRIO work with redundant control logix processors?
Viewed 1 times since Mon, Aug 24, 2015
Yes, AN-X2-AB-DHRIO are capable of communicating via EtherNet/IP with a control logix system that had redundant processors. Read More
How to figure out what the IP Address of an AN-X2 gateway is?
Viewed 1 times since Mon, Sep 29, 2014
There are 2 ways to determine the current IP Address of an AN-X2 gateway. If AnxInit is installed on the PC, then AN-X2 modules will respond to the locate all query that can be found under the Utilities menu. (Note: AnxInit is not able to... Read More
Which firmware should I use for a DH+ PLC to an EtherNet/IP HMI
Viewed 1 times since Wed, Feb 24, 2016
If you intend to use an AN-X2-AB-DHRIO to connect anything, including an HMI, on EtherNet/IP to something on Data Highway Plus, you will be using the DHP firmware. The HMI firmware is for use only with connecting HMIs like panel views to Remote I/O... Read More
What does the mSD card do on the AN-X2 platform?
Viewed 1 times since Tue, Jul 29, 2014
The purpose of the mSD card is to facilitate the swapping out of a failed AN-X2 gateway with a new AN-X2 gateway without the need for configuring the new gateway. The mSD card is used to store configuration files and the firmware files for the... Read More
My AN-X2-AB-DHRIO Web GUI is missing the Automation Network tab
Viewed 1 times since Tue, Aug 25, 2015
The AN-X2-AB-DHRIO is a multi-purpose gateway which comes shipped with multiple different firmwares built in, but only one active at any given time. Any given firmware may have different tabs then the others. Every firmware, however, should have the... Read More
|
||||||||