Home » Categories » Rockwell In-chassis |
Does the ladder logic or Add-On Instruction for my InRAx module need to be installed in order to access the Debug Menu? |
Article Number: 128 | Rating: 1/5 from 1 votes | Last Updated: Tue, Jul 1, 2014 at 11:46 PM |
Yes, the ladder logic must be installed and running in the processor for the debug menu to be available. If the ladder logic is not installed, or is configured incorrectly, the OK LED on the module will show red, and the debug menu will not be available. If the required logic is in place and running properly, the OK LED will show green and the debug menu will be available. |
Attachments (0)
![]()
There are no attachments for this article.
|
Comments
![]()
There are no comments for this article. Be the first to post a comment.
|
Are any ProSoft solutions SIL2 rated?
Viewed 1 times since Tue, Oct 14, 2008
Array Subscript too Large Controller Fault
Viewed 1 times since Mon, Jan 18, 2016
I cannot locate the .EDS file for my ProSoft Product. Where can I get the proper .EDS file for my module?
Viewed 1 times since Thu, May 5, 2016
How do I completely remove a ProSoft Add-On Instruction (AOI) from an RSLogix5000 project?
Viewed 1 times since Wed, Sep 28, 2011
|