Home » Categories » Protocols » HART

The Hart Manual shows the network connector on the front of the gateway device. It has a connection for 24vdc. Is this jumpered internally, or do I need to connect 24vdc to the gateway in two diffe
Article Number: 179 | Rating: Unrated | Last Updated: Thu, Jan 17, 2008 at 12:00 AM
Power must be supplied to both power connections. You can use the same power source, but we recommend a separate power supply for each connection
Custom Fields
    Posted by: Technical Support - Tue, Nov 28, 2006 at 2:17 PM This article has been viewed 22186 times.
    Filed Under: HART
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Icon Add Comment
    Name
    Email (Required, but not published)
    Comment
    Security Code Security Code
     
    Related Articles RSS Feed
    Why am I getting communications errors on my HART devices?
    Viewed 1 times since Tue, Nov 28, 2006
    Does ProSoft make any HART Slave solutions, which will acquire data on an RS232 port and allow it to be read by a HART Master?
    Viewed 1 times since Wed, Mar 5, 2008
    What version of the HART protocol is supported in ProSoft HART solutions?
    Viewed 1 times since Wed, Dec 3, 2008
    What is the typical update rate of the HART devices when using HART modules?
    Viewed 1 times since Wed, Nov 29, 2006
    • Icon SubscriberSubscribe to Article
    • Icon PrinterPrint Article
    • Icon EmailEmail Article to Friend
    • Icon PDFExport to PDF
    • Icon MS-WordExport to MS Word
    • Icon TwitterTweet This Article
    • Icon DiggDigg It
    • Icon StumbleuponStumble Upon
    • Icon de.icio.usDel.icio.us
    Article Rating (No Votes)
    Rate this article
    Powered by PHPKB Knowledge Base Software