Home » Categories » Protocols » HART

What is the typical update rate of the HART devices when using HART modules?
Article Number: 271 | Rating: Unrated | Last Updated: Mon, Jul 14, 2014 at 11:49 PM
As the HART protocol communicates at 1200 baud, expect HART update times around 500ms per device on the network.
Custom Fields
    Posted by: Technical Support - Wed, Nov 29, 2006 at 8:05 AM This article has been viewed 21469 times.
    Filed Under: HART
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Icon Add Comment
    Name
    Email (Required, but not published)
    Comment
    Security Code Security Code
     
    Related Articles RSS Feed
    The Hart Manual shows the network connector on the front of the gateway device. It has a connection for 24vdc. Is this jumpered internally, or do I need to connect 24vdc to the gateway in two diffe
    Viewed 1 times since Tue, Nov 28, 2006
    Why am I getting communications errors on my HART devices?
    Viewed 1 times since Tue, Nov 28, 2006
    Does ProSoft make any HART Slave solutions, which will acquire data on an RS232 port and allow it to be read by a HART Master?
    Viewed 1 times since Wed, Mar 5, 2008
    What version of the HART protocol is supported in ProSoft HART solutions?
    Viewed 1 times since Wed, Dec 3, 2008
    • Icon SubscriberSubscribe to Article
    • Icon PrinterPrint Article
    • Icon EmailEmail Article to Friend
    • Icon PDFExport to PDF
    • Icon MS-WordExport to MS Word
    • Icon TwitterTweet This Article
    • Icon DiggDigg It
    • Icon StumbleuponStumble Upon
    • Icon de.icio.usDel.icio.us
    Article Rating (No Votes)
    Rate this article
    Powered by PHPKB Knowledge Base Software