KB Home \| Advanced Search \| News \| Ask Question
ProSoft Knowledge Base

Why do I get an error 3 on the MVIbp_Open function call on my MVI56-ADM?

Article Number: 207 | Rating: Unrated | Last Updated: Thu, Jan 17, 2008 at 12:00 AM

If you are using the backplane API you need to execute in the autoexec.bat the program mvi56dd.exe before executing your application. This program is a device driver that allows your application to communicate to the backplane.

Custom Fields

Attachments (0)

Attachments

There are no attachments for this article.

Comments

Comments

There are no comments for this article. Be the first to post a comment.

Related Articles

How can I edit the backplane exchange size on the MVI56-ADM?

Viewed 1 times since Tue, Dec 14, 2010

How do I transfer data from a PLC5 Processor and the MVI71-ADM module using Block Transfers?

Viewed 1 times since Tue, Nov 28, 2006

What Compact Flash card does ProSoft recommend using with my ADM solutions

Viewed 1 times since Wed, Nov 29, 2006

How do I compile and build my C program for the ADM module?

Viewed 1 times since Tue, Nov 28, 2006

What are the basic memory specs for the MVI56-ADM?

Viewed 1 times since Wed, Nov 29, 2006

Why do I get the message "Extra ignored!" in my MVI56-BAS module?

Viewed 1 times since Tue, Nov 28, 2006

What are the differences between the Rockwell 1756-MVI and the MVI56-ADM module? Can I change an MVI56-ADM module to run the same firmware as a 1756-MVI module?

Viewed 1 times since Tue, Nov 28, 2006

MVI56-ADM module: "Device not available" error is shown on the MVIbp_Open function call.

Viewed 1 times since Tue, Nov 28, 2006

How do I configure my ADM project to work with a particular MVI platform I am using?

Viewed 1 times since Tue, Nov 28, 2006

Difference between MVI94-DOS and MVI94-ADM?

Viewed 1 times since Tue, Nov 28, 2006