KB Home \| Advanced Search \| News \| Ask Question
ProSoft Knowledge Base

MVI56-ADM module: "Device not available" error is shown on the MVIbp_Open function call.

Article Number: 88 | Rating: 5/5 from 1 votes | Last Updated: Tue, Jul 1, 2014 at 5:53 PM

The MVI56DD.exe file must be run in the config.sys file. The following line should be added to the config.sys file:

install = a:MVI56DD.exe

Custom Fields

Attachments (0)

Attachments

There are no attachments for this article.

Comments

Comments

There are no comments for this article. Be the first to post a comment.

Related Articles

How do I compile and build my C program for the ADM module?

Viewed 1 times since Tue, Nov 28, 2006

Difference between MVI94-DOS and MVI94-ADM?

Viewed 1 times since Tue, Nov 28, 2006

What are the differences between the Rockwell 1756-MVI and the MVI56-ADM module? Can I change an MVI56-ADM module to run the same firmware as a 1756-MVI module?

Viewed 1 times since Tue, Nov 28, 2006

How do I configure my ADM project to work with a particular MVI platform I am using?

Viewed 1 times since Tue, Nov 28, 2006

How do I transfer data from a PLC5 Processor and the MVI71-ADM module using Block Transfers?

Viewed 1 times since Tue, Nov 28, 2006

What Compact Flash card does ProSoft recommend using with my ADM solutions

Viewed 1 times since Wed, Nov 29, 2006

What are the basic memory specs for the MVI56-ADM?

Viewed 1 times since Wed, Nov 29, 2006

Why do I get the message "Extra ignored!" in my MVI56-BAS module?

Viewed 1 times since Tue, Nov 28, 2006

How can I edit the backplane exchange size on the MVI56-ADM?

Viewed 1 times since Tue, Dec 14, 2010

Why do I get an error 3 on the MVIbp_Open function call on my MVI56-ADM?

Viewed 1 times since Tue, Nov 28, 2006