Home » Categories » Rockwell In-chassis » Programmable Modules

How can I edit the backplane exchange size on the MVI56-ADM?
Article Number: 452 | Rating: 5/5 from 1 votes | Last Updated: Tue, Jul 1, 2014 at 5:57 PM
First use the MVIcip_open function to open the backplane then you will need to use   'MVIcip_WriteConnected' function call and the 'MVIcip_ReadConnected' function call to change the I/O size.  
 
The last argument of the these two functions (MVIcip_WriteConnected and MVIcip_ReadConnected) is the dataSize argument in size of bytes.  The detail on how to use these two functions can be found on page 273 of 348 and page 274 of 348 on the adm_dev_guide respectively. 
Custom Fields
    Posted by: Administrator - Tue, Dec 14, 2010 at 8:24 AM This article has been viewed 2857 times.
    Filed Under: Programmable Modules
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Icon Add Comment
    Name
    Email (Required, but not published)
    Comment
    Security Code Security Code
     
    Related Articles RSS Feed
    Why do I get an error 3 on the MVIbp_Open function call on my MVI56-ADM?
    Viewed 1 times since Tue, Nov 28, 2006
    Why do I get the message "Extra ignored!" in my MVI56-BAS module?
    Viewed 1 times since Tue, Nov 28, 2006
    How do I transfer data from a PLC5 Processor and the MVI71-ADM module using Block Transfers?
    Viewed 1 times since Tue, Nov 28, 2006
    MVI56-ADM module: "Device not available" error is shown on the MVIbp_Open function call.
    Viewed 1 times since Tue, Nov 28, 2006
    How do I configure my ADM project to work with a particular MVI platform I am using?
    Viewed 1 times since Tue, Nov 28, 2006
    How do I compile and build my C program for the ADM module?
    Viewed 1 times since Tue, Nov 28, 2006
    Difference between MVI94-DOS and MVI94-ADM?
    Viewed 1 times since Tue, Nov 28, 2006
    What are the differences between the Rockwell 1756-MVI and the MVI56-ADM module? Can I change an MVI56-ADM module to run the same firmware as a 1756-MVI module?
    Viewed 1 times since Tue, Nov 28, 2006
    What Compact Flash card does ProSoft recommend using with my ADM solutions
    Viewed 1 times since Wed, Nov 29, 2006
    What are the basic memory specs for the MVI56-ADM?
    Viewed 1 times since Wed, Nov 29, 2006
    • Icon SubscriberSubscribe to Article
    • Icon PrinterPrint Article
    • Icon EmailEmail Article to Friend
    • Icon PDFExport to PDF
    • Icon MS-WordExport to MS Word
    • Icon TwitterTweet This Article
    • Icon DiggDigg It
    • Icon StumbleuponStumble Upon
    • Icon de.icio.usDel.icio.us
    Article Rating (1 Votes)
    Rate this article
    Powered by PHPKB Knowledge Base Software