Home » Categories » Protocols » ModbusTCP/IP

How do I setup a Modicon Ethernet I/O scanner to a ProSoft/ProLinx MNET device?
Article Number: 235 | Rating: 1/5 from 1 votes | Last Updated: Fri, Jan 18, 2008 at 12:00 AM
All MNET products the following document will step the user through the setup and configuration of a EtherNet I/O scanner within a modicon quantum processor. This same information can also be used with a momentum, or other Modbus TCP/IP I/O scanner devices.
Custom Fields
    Posted by: Technical Support - Tue, Nov 28, 2006 at 4:14 PM This article has been viewed 24260 times.
    Filed Under: ModbusTCP/IP
    Attachments (1) Attachments
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Icon Add Comment
    Name
    Email (Required, but not published)
    Comment
    Security Code Security Code
     
    Related Articles RSS Feed
    On the MVI56E product line what is the difference between your Modbus TCP communications modules MNET, MNETR, MNETC, MNETCR?
    Viewed 1 times since Tue, Jan 23, 2007
    Do any Prosoft modules support Modbus UDP?
    Viewed 1 times since Mon, Aug 24, 2015
    What does a -36 modbus error code indicate?
    Viewed 1 times since Thu, Aug 20, 2015
    The MVI56-MNET is limited to 100 commands. Is there a way to increase this?
    Viewed 1 times since Wed, Mar 19, 2008
    • Icon SubscriberSubscribe to Article
    • Icon PrinterPrint Article
    • Icon EmailEmail Article to Friend
    • Icon PDFExport to PDF
    • Icon MS-WordExport to MS Word
    • Icon TwitterTweet This Article
    • Icon DiggDigg It
    • Icon StumbleuponStumble Upon
    • Icon de.icio.usDel.icio.us
    Article Rating (1 Votes)
    Rate this article
    Powered by PHPKB Knowledge Base Software