| Home » Categories » Multiple Categories |
Do any Prosoft modules support Modbus UDP? |
| Article Number: 570 | Rating: Unrated | Last Updated: Tue, Nov 3, 2015 at 7:53 PM |
| Prosoft does not currently offer any UDP based Modbus solutions, all modbus solutions offered via Ethernet are Modbus TCP/IP only. |
Attachments (0)
There are no attachments for this article.
|
Comments
There are no comments for this article. Be the first to post a comment.
 Add Comment |
Related Articles 
How can a module's Modbus port, configured as a Slave port, detect communication loss with the Master port?
Viewed 1 times since Tue, Nov 28, 2006
My RX light is on solid, what might that indicate?
Viewed 1 times since Fri, Jul 17, 2015
What are the causes of a -11 error code using a ProSoft Modbus product?
Viewed 1 times since Mon, May 17, 2010
The MVI56-MNET is limited to 100 commands. Is there a way to increase this?
Viewed 1 times since Wed, Mar 19, 2008
How do you detect the individual Slave failure?
Viewed 1 times since Wed, Nov 29, 2006
Read Commands from my Modbus Master to a ProSoft MCM Slave are working but Write Commands are failing. How do I fix this?
Viewed 1 times since Fri, Feb 8, 2008
How do I setup a Modicon Ethernet I/O scanner to a ProSoft/ProLinx MNET device?
Viewed 1 times since Tue, Nov 28, 2006
If I am reading the value from ProSoft 4x register, and it represents a digital input or digital output, how is the value stored?
Viewed 1 times since Tue, Nov 28, 2006
How do I monitor the health of coms to my slaves when the module is a Master?
Viewed 1 times since Wed, Nov 29, 2006
Can Modbus support redundant masters?
Viewed 1 times since Tue, Nov 28, 2006
|
| KB Home | Advanced Search | News | Ask Question |
|
| ProSoft Knowledge Base |  |
|
|
|
Subscribe to Article
Print Article
Email Article to Friend
Export to PDF
Export to MS Word
Tweet This Article
Digg It
Stumble Upon
Del.icio.us