Home » Categories » Protocols » ModbusTCP/IP

The MVI56-MNET is limited to 100 commands. Is there a way to increase this?
Article Number: 380 | Rating: Unrated | Last Updated: Thu, Feb 26, 2015 at 5:36 PM
Not without using Event Commands. If this module is going to be used only as a client (master), then you can use the MVI56-MNETC, which has a total of 480 commands, 16 commands for each of 30 Clients.
Custom Fields
    Posted by: Administrator - Wed, Mar 19, 2008 at 6:46 AM This article has been viewed 19161 times.
    Filed Under: ModbusTCP/IP
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Icon Add Comment
    Name
    Email (Required, but not published)
    Comment
    Security Code Security Code
     
    Related Articles RSS Feed
    What does a -36 modbus error code indicate?
    Viewed 1 times since Thu, Aug 20, 2015
    Do any Prosoft modules support Modbus UDP?
    Viewed 1 times since Mon, Aug 24, 2015
    How do I setup a Modicon Ethernet I/O scanner to a ProSoft/ProLinx MNET device?
    Viewed 1 times since Tue, Nov 28, 2006
    On the MVI56E product line what is the difference between your Modbus TCP communications modules MNET, MNETR, MNETC, MNETCR?
    Viewed 1 times since Tue, Jan 23, 2007
    • Icon SubscriberSubscribe to Article
    • Icon PrinterPrint Article
    • Icon EmailEmail Article to Friend
    • Icon PDFExport to PDF
    • Icon MS-WordExport to MS Word
    • Icon TwitterTweet This Article
    • Icon DiggDigg It
    • Icon StumbleuponStumble Upon
    • Icon de.icio.usDel.icio.us
    Article Rating (No Votes)
    Rate this article
    Powered by PHPKB Knowledge Base Software