Home » Categories » Gateways » 7000 Series - AppSrvCE

What are the default IP Addresses on an AppSrvCE unit?
Article Number: 320 | Rating: 2/5 from 3 votes | Last Updated: Mon, Jun 30, 2014 at 11:01 PM

The factory default configuration of the AppSrvCE Ethernet Ports is as Follows:

Left Port: IP = 192.168.0.1 NetMask = 255.255.255.0

Right Port: IP = Is obtained using DHCP

The easiest way to connect to an AppServer is to connect using the left port, and then configure both ethernet ports for your application.
Custom Fields
    Posted by: Administrator - Thu, Jan 25, 2007 at 1:46 PM This article has been viewed 50216 times.
    Filed Under: 7000 Series - AppSrvCE
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Icon Add Comment
    Name
    Email (Required, but not published)
    Comment
    Security Code Security Code
     
    Related Articles RSS Feed
    I get an "echoxmlcfg failure" message whenever I try to download an EZ-Studio project to my ProSoft 7000 Historian. How do I fix this?
    Viewed 1 times since Wed, Mar 5, 2008
    How can I use fault code 0x00000035 (PWR_DWN_5V_LOSS Power supply is below 5v. Shutdown is eminent) or any other fault code(s) to trigger a shutdown on AppSrv module?
    Viewed 1 times since Wed, Dec 23, 2009
    How do I setup the IP Address in an AppSrvCE?
    Viewed 1 times since Thu, Jan 25, 2007
    Every attempt to download an EZ-Studio project to the AppServ module results in an "echoxmlcfg" failure. How do I fix this?
    Viewed 1 times since Mon, Feb 18, 2008
    What can I do to troubleshoot connection problems between Echo Historian and OPC/SLS servers on the PC56/PC56CE/7000AppSrvCE platforms?
    Viewed 1 times since Wed, Feb 6, 2008
    How do I change the video display resolution in the AppSrv?
    Viewed 1 times since Wed, Nov 29, 2006
    Why is COM port 1 not available on the AppSrvCE unit?
    Viewed 1 times since Mon, Jun 30, 2014
    How do I get AppServCE applications to Auto-Start on power-up?
    Viewed 1 times since Thu, Apr 24, 2008
    I'm not able to create more than 7 interfaces in my EZStudio project, how can I add more interfaces?
    Viewed 1 times since Thu, Jan 25, 2007
    How do I do a Remote Display Connection with the AppSrvCE?
    Viewed 1 times since Thu, Jan 25, 2007
    • Icon SubscriberSubscribe to Article
    • Icon PrinterPrint Article
    • Icon EmailEmail Article to Friend
    • Icon PDFExport to PDF
    • Icon MS-WordExport to MS Word
    • Icon TwitterTweet This Article
    • Icon DiggDigg It
    • Icon StumbleuponStumble Upon
    • Icon de.icio.usDel.icio.us
    Article Rating (3 Votes)
    Rate this article
    Powered by PHPKB Knowledge Base Software