Home » Categories » Gateways » AN-X » AutoMax

Does the AN-X-AMX support RNET?
Article Number: 513 | Rating: Unrated | Last Updated: Fri, Jul 25, 2014 at 10:23 PM
The AN-X-AMX does not support the RNET protocol which was used on the old AutoMate 30 series processors.
Custom Fields
    Posted by: Administrator - Fri, Jul 25, 2014 at 10:23 PM This article has been viewed 1911 times.
    Filed Under: AutoMax
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Icon Add Comment
    Name
    Email (Required, but not published)
    Comment
    Security Code Security Code
     
    Related Articles RSS Feed
    What is the default addressing schema for the EtherNet IP DCSNet(2) Slave interface?
    Viewed 1 times since Wed, Dec 31, 2014
    What are the differences between the DCSNet and DCSNet2 firmware?
    Viewed 1 times since Mon, Sep 29, 2014
    Is it possible for a FactoryTalk View application to get data from a DCSNet(2) AN-X-AMX Slave?
    Viewed 1 times since Wed, Dec 31, 2014
    When operating as a DCSNet(2) slave can the AN-X-AMX gateway be configured to emulate more than 1 drop area?
    Viewed 1 times since Mon, Sep 29, 2014
    • Icon SubscriberSubscribe to Article
    • Icon PrinterPrint Article
    • Icon EmailEmail Article to Friend
    • Icon PDFExport to PDF
    • Icon MS-WordExport to MS Word
    • Icon TwitterTweet This Article
    • Icon DiggDigg It
    • Icon StumbleuponStumble Upon
    • Icon de.icio.usDel.icio.us
    Article Rating (No Votes)
    Rate this article
    Powered by PHPKB Knowledge Base Software