KB Home \| Advanced Search \| News \| Ask Question
ProSoft Knowledge Base

What is the default addressing schema for the EtherNet IP DCSNet(2) Slave interface?

Article Number: 534 | Rating: Unrated | Last Updated: Wed, Dec 31, 2014 at 2:15 PM

When using the DCSNet(2) firmware in a slave configuration the addresses use the following layout: Drop 0 = N100:0 - N100:63 Drop 1 = N101:0 - N101:63 Drop 2 = N102:0 - N102:63 etc.... The first 32 registers (0 - 31) contains the data that will be sent to the AutoMax controller, and the second 32 registers (32 - 63) contains the data coming from the AutoMax controller.

Custom Fields

Attachments (0)

There are no attachments for this article.

Comments

There are no comments for this article. Be the first to post a comment.

Is it possible for a FactoryTalk View application to get data from a DCSNet(2) AN-X-AMX Slave?

Viewed 1 times since Wed, Dec 31, 2014

What are the differences between the DCSNet and DCSNet2 firmware?

Viewed 1 times since Mon, Sep 29, 2014

Does the AN-X-AMX support RNET?

Viewed 1 times since Fri, Jul 25, 2014

When operating as a DCSNet(2) slave can the AN-X-AMX gateway be configured to emulate more than 1 drop area?

Viewed 1 times since Mon, Sep 29, 2014