KB Home \| Advanced Search \| News \| Ask Question
ProSoft Knowledge Base

Is it possible for a FactoryTalk View application to get data from a DCSNet(2) AN-X-AMX Slave?

Article Number: 535 | Rating: Unrated | Last Updated: Wed, Dec 31, 2014 at 2:26 PM

Yes, To do so create an ethernet device by right clicking on EtherNet: Browse the NET ENI folder Browse the PLC5 Folder Select the 2nd PLC5 in the list which is the PLC5 L40C When prompted enter the IP Address of the AN-X-AMX gateway Map your Shortcut to this device Click verify Click the copy from design time to run time button.

Custom Fields

Attachments (0)

There are no attachments for this article.

Comments

There are no comments for this article. Be the first to post a comment.

What are the differences between the DCSNet and DCSNet2 firmware?

Viewed 1 times since Mon, Sep 29, 2014

What is the default addressing schema for the EtherNet IP DCSNet(2) Slave interface?

Viewed 1 times since Wed, Dec 31, 2014

When operating as a DCSNet(2) slave can the AN-X-AMX gateway be configured to emulate more than 1 drop area?

Viewed 1 times since Mon, Sep 29, 2014

Does the AN-X-AMX support RNET?

Viewed 1 times since Fri, Jul 25, 2014