Home » Categories » Protocols » Modbus Plus

When using a Prolinx Gateway Modbus Plus module, what register in the module is used to publish Global Output Data?
Article Number: 118 | Rating: Unrated | Last Updated: Fri, Jan 18, 2008 at 12:00 AM

The Modbus Plus driver uses register 3960 in the modules database as the starting address to publish global data on the Modbus Plus network.The total number of registers is 32.

Related Keywords:

4301 4302 4303 4304 4305 4306 4307 4310
Custom Fields
    Posted by: Technical Support - Tue, Nov 28, 2006 at 10:55 AM This article has been viewed 49606 times.
    Filed Under: Modbus Plus
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Icon Add Comment
    Name
    Email (Required, but not published)
    Comment
    Security Code Security Code
     
    Related Articles RSS Feed
    What Modbus Plus Cable do I use with the MVIxx-MBP modules when using Modicon Tap #990NAD23000?
    Viewed 1 times since Tue, Nov 28, 2006
    How can I create the Device Definition Table and Modbus Plus Route Paths?
    Viewed 1 times since Tue, Feb 19, 2008
    What is the correct function code to use when reading and writing with an MBP Modbus Plus module?
    Viewed 1 times since Tue, Nov 28, 2006
    Cable hardware requirements for Modbus Plus networking.
    Viewed 1 times since Tue, Nov 28, 2006
    Where is the Global output data mapped in the Modbus Plus (MBP) ProLinx module?
    Viewed 1 times since Tue, Nov 28, 2006
    • Icon SubscriberSubscribe to Article
    • Icon PrinterPrint Article
    • Icon EmailEmail Article to Friend
    • Icon PDFExport to PDF
    • Icon MS-WordExport to MS Word
    • Icon TwitterTweet This Article
    • Icon DiggDigg It
    • Icon StumbleuponStumble Upon
    • Icon de.icio.usDel.icio.us
    Article Rating (No Votes)
    Rate this article
    Powered by PHPKB Knowledge Base Software