Home » Categories » Protocols » Modbus Plus

Where is the Global output data mapped in the Modbus Plus (MBP) ProLinx module?
Article Number: 74 | Rating: Unrated | Last Updated: Mon, Jun 30, 2014 at 11:15 PM
All ProLinx MBP modules global output data is mapped to addresses 3960 - 4000 in the ProLinx module.
Custom Fields
    Posted by: Technical Support - Tue, Nov 28, 2006 at 10:10 AM This article has been viewed 48650 times.
    Filed Under: Modbus Plus
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Icon Add Comment
    Name
    Email (Required, but not published)
    Comment
    Security Code Security Code
     
    Related Articles RSS Feed
    How can I create the Device Definition Table and Modbus Plus Route Paths?
    Viewed 1 times since Tue, Feb 19, 2008
    What is the correct function code to use when reading and writing with an MBP Modbus Plus module?
    Viewed 1 times since Tue, Nov 28, 2006
    When using a Prolinx Gateway Modbus Plus module, what register in the module is used to publish Global Output Data?
    Viewed 1 times since Tue, Nov 28, 2006
    Cable hardware requirements for Modbus Plus networking.
    Viewed 1 times since Tue, Nov 28, 2006
    What Modbus Plus Cable do I use with the MVIxx-MBP modules when using Modicon Tap #990NAD23000?
    Viewed 1 times since Tue, Nov 28, 2006
    • Icon SubscriberSubscribe to Article
    • Icon PrinterPrint Article
    • Icon EmailEmail Article to Friend
    • Icon PDFExport to PDF
    • Icon MS-WordExport to MS Word
    • Icon TwitterTweet This Article
    • Icon DiggDigg It
    • Icon StumbleuponStumble Upon
    • Icon de.icio.usDel.icio.us
    Article Rating (No Votes)
    Rate this article
    Powered by PHPKB Knowledge Base Software