Home » Categories » Protocols » Modbus Plus

What Modbus Plus Cable do I use with the MVIxx-MBP modules when using Modicon Tap #990NAD23000?
Article Number: 202 | Rating: Unrated | Last Updated: Thu, Jan 17, 2008 at 12:00 AM

When using the modicon cable and tap system, you will want to use cable #990nad21910. This cable has a right angle connector that will fit on the MVIXXX-MBP module. Do not use #990NAD21110 as this cable will not fit onto the connector of the MVI module.

Related Keywords: MVI46MBP MVI56MBP
Custom Fields
    Posted by: Technical Support - Tue, Nov 28, 2006 at 3:20 PM This article has been viewed 22688 times.
    Filed Under: Modbus Plus
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Icon Add Comment
    Name
    Email (Required, but not published)
    Comment
    Security Code Security Code
     
    Related Articles RSS Feed
    Where is the Global output data mapped in the Modbus Plus (MBP) ProLinx module?
    Viewed 1 times since Tue, Nov 28, 2006
    When using a Prolinx Gateway Modbus Plus module, what register in the module is used to publish Global Output Data?
    Viewed 1 times since Tue, Nov 28, 2006
    How can I create the Device Definition Table and Modbus Plus Route Paths?
    Viewed 1 times since Tue, Feb 19, 2008
    Cable hardware requirements for Modbus Plus networking.
    Viewed 1 times since Tue, Nov 28, 2006
    What is the correct function code to use when reading and writing with an MBP Modbus Plus module?
    Viewed 1 times since Tue, Nov 28, 2006
    Article Rating (No Votes)
    Rate this article
    Powered by PHPKB Knowledge Base Software