| Home » Categories » Multiple Categories |
Connecting RS232/Channel 0 port on my V17 or V18 Logix processor to connect to my ProSoft device halts communications.. |
| Article Number: 446 | Rating: Unrated | Last Updated: Tue, Jul 1, 2014 at 3:12 PM |
|
This is a known issue with Allen Bradley and AB Technote #67950 has been created.
"There is an anomaly with all Logix processors in V17 and V18 in which the serial port UART may stall when transmitting packets. This has only appeared on certain devices connected to the serial port and is dependent upon the electrical load placed on the port. (not all devices can cause this issue to occur)...."
Please see AB Technote #67950 for more information, along with a sample ladder (.ACD file) work-around. (login required) |
Attachments (0)
There are no attachments for this article.
|
Comments
There are no comments for this article. Be the first to post a comment.
 Add Comment |
Related Articles 
What are the power requirements for the MVI69 CompactLogix modules?
Viewed 1 times since Tue, Nov 28, 2006
What causes a conditional command to be issued?
Viewed 1 times since Tue, Nov 28, 2006
Where are the on-board jumper positions defined for my MVI module?
Viewed 1 times since Tue, Nov 28, 2006
Which of your products support RS-485 serial protocols?
Viewed 1 times since Wed, Feb 6, 2008
Baud rate entries greater than 32767 in ProSoft Modules
Viewed 1 times since Tue, Nov 28, 2006
Do the serial ports on my MVI56 module provide any electrical isolation?
Viewed 1 times since Tue, Nov 28, 2006
|
| KB Home | Advanced Search | News | Ask Question |
|
| ProSoft Knowledge Base |  |
|
|
|
Subscribe to Article
Print Article
Email Article to Friend
Export to PDF
Export to MS Word
Tweet This Article
Digg It
Stumble Upon
Del.icio.us