Home » Categories » Multiple Categories

When using the sample ladder I get an M0/M1 file reference error in my SLC processor if the MVI46 or 3150 is not in Slot 1.
Article Number: 72 | Rating: 5/5 from 1 votes | Last Updated: Thu, Jun 19, 2014 at 8:12 PM
The M0 and M1 files are slot referenced. The second digit in the address represents the slot number.
  • If the MVI46 or 3150 module is in slot 1 (next to the processor), then the file reference is M0:1.XXXX and M1:1.XXXX
  • If the module is in slot 5, then the file reference would be MO:G>5.xxxx and m1:5.xxxx

The same slot reference applies to input and output files (i and o references)

Custom Fields
    Posted by: Technical Support - Tue, Nov 28, 2006 at 10:09 AM This article has been viewed 50894 times.
    Filed Under: 3150 Series, MVI46 Series
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Icon Add Comment
    Name
    Email (Required, but not published)
    Comment
    Security Code Security Code
     
    Related Articles RSS Feed
    I am using a ProSoft MVI46 solution and I am getting a Fault Message that says, "Specialty I/O Module in Slot x has not responded within the time limit." What can cause this?
    Viewed 1 times since Fri, Oct 31, 2008
    My MVI46 module faults the processor after cycling power to the rack.
    Viewed 1 times since Tue, Nov 28, 2006
    What are the advantages of the MVI46-MCM compare to the 3150-MCM?
    Viewed 1 times since Tue, Nov 28, 2006
    Debug port connection parameters for Prosoft modules and gateways
    Viewed 1 times since Tue, Nov 28, 2006
    Can the MVI46 or 3150 modules be placed in a remote rack?
    Viewed 1 times since Tue, Nov 28, 2006
    IEC-60870-5-104 Server Tutorial
    Viewed 1 times since Mon, Sep 3, 2012
    Which of your products support RS-485 serial protocols?
    Viewed 1 times since Wed, Feb 6, 2008
    Where can I locate the User Manual for the MVI46-MCM
    Viewed 1 times since Tue, Nov 28, 2006
    My 3150-MCM block IDs are incrementing until I connect the communications cable. Once the cable is connected, the block ID stops incrementing.
    Viewed 1 times since Tue, Nov 28, 2006
    How to enable Modbus commands in MVI46-MNETC
    Viewed 1 times since Wed, Sep 24, 2014
    • Icon SubscriberSubscribe to Article
    • Icon PrinterPrint Article
    • Icon EmailEmail Article to Friend
    • Icon PDFExport to PDF
    • Icon MS-WordExport to MS Word
    • Icon TwitterTweet This Article
    • Icon DiggDigg It
    • Icon StumbleuponStumble Upon
    • Icon de.icio.usDel.icio.us
    Article Rating (1 Votes)
    Rate this article
    Powered by PHPKB Knowledge Base Software