Home » Categories » Rockwell In-chassis » SLC » MVI46 Series

What are the advantages of the MVI46-MCM compare to the 3150-MCM?
Article Number: 43 | Rating: Unrated | Last Updated: Fri, Jan 18, 2008 at 12:00 AM

Here are some of the main advantages of the MVI46-MCM over the 3150-MCM:

  • Direct M0/M1 file access, makes it much easier to configure
  • You do not need to page memory as the 3150-MCM supports baud rates to 115.2 (3150 only to 38.4)
  • 100 Modbus master commands on each port (200 total). 3150 only supported 100 commands
  • Dedicated debug port and built in data analyzer to monitor data flow and to ease trouble-shooting.
  • Field flash upgradeable
Custom Fields
    Posted by: Technical Support - Tue, Nov 28, 2006 at 9:11 AM This article has been viewed 49650 times.
    Filed Under: MVI46 Series
    Attachments (0) Attachments
    There are no attachments for this article.
    Comments Comments
    There are no comments for this article. Be the first to post a comment.
    Icon Add Comment
    Name
    Email (Required, but not published)
    Comment
    Security Code Security Code
     
    Related Articles RSS Feed
    How do I deal with an unsigned integer in an SLC, PLC5, or MicroLogix processor?
    Viewed 1 times since Tue, Jan 23, 2007
    I am using a ProSoft MVI46 solution and I am getting a Fault Message that says, "Specialty I/O Module in Slot x has not responded within the time limit." What can cause this?
    Viewed 1 times since Fri, Oct 31, 2008
    When using the sample ladder I get an M0/M1 file reference error in my SLC processor if the MVI46 or 3150 is not in Slot 1.
    Viewed 1 times since Tue, Nov 28, 2006
    IEC-60870-5-104 Server Tutorial
    Viewed 1 times since Mon, Sep 3, 2012
    Where can I locate the User Manual for the MVI46-MCM
    Viewed 1 times since Tue, Nov 28, 2006
    Is there a limit to the number of ProSoft modules I can place in my SLC chassis?
    Viewed 1 times since Tue, Nov 28, 2006
    Can the MVI46 or 3150 modules be placed in a remote rack?
    Viewed 1 times since Tue, Nov 28, 2006
    How to enable Modbus commands in MVI46-MNETC
    Viewed 1 times since Wed, Sep 24, 2014
    Debug port connection parameters for Prosoft modules and gateways
    Viewed 1 times since Tue, Nov 28, 2006
    My MVI46 module faults the processor after cycling power to the rack.
    Viewed 1 times since Tue, Nov 28, 2006
    • Icon SubscriberSubscribe to Article
    • Icon PrinterPrint Article
    • Icon EmailEmail Article to Friend
    • Icon PDFExport to PDF
    • Icon MS-WordExport to MS Word
    • Icon Bookmark Bookmark Article (CTRL-D)
    • Icon TwitterTweet This Article
    • Icon DiggDigg It
    • Icon StumbleuponStumble Upon
    • Icon de.icio.usDel.icio.us
    Article Rating (No Votes)
    Rate this article
    Powered by PHPKB Knowledge Base Software