KB Home \| Advanced Search \| News \| Ask Question
ProSoft Knowledge Base

IEC-60870-5-104 Server Tutorial

Article Number: 477 | Rating: Unrated | Last Updated: Thu, Jul 17, 2014 at 5:08 PM

The following document outlines the ProSoft implementation of the IEC-60870-5-104 Server communication module as pertains to all -104S products.

Custom Fields

Attachments (1)

Attachments

tn120904_001_iec60870-5-104_server_tutorial.pdf ( 8701 Views, 1.08 MB )

Comments

Comments

There are no comments for this article. Be the first to post a comment.

Related Articles

How to upload a configuration file from 4xxx or 5xxx Gateway?

Viewed 1 times since Tue, Nov 28, 2006

I have a xxxx-xxx-DFCM4 with Pass-Through enabled. The Pass-Through (Debug/CFG) port and the Port 0 DFCM port shows no activity. What am I doing wrong?

Viewed 1 times since Tue, Nov 28, 2006

How to enable Modbus commands in MVI46-MNETC

Viewed 1 times since Wed, Sep 24, 2014

Is the MVI69 series of ProSoft modules compatible with the MicroLogix1500 processor?

Viewed 1 times since Tue, Nov 28, 2006

What is the function of the "Delay Preset" in the Data Map section?

Viewed 1 times since Tue, Nov 28, 2006

Which of your products support RS-485 serial protocols?

Viewed 1 times since Wed, Feb 6, 2008

When the MVI71-MCM is connected using Side-Connect, can a Modbus Master device read and write to the same Modbus address in the module?

Viewed 1 times since Tue, Nov 28, 2006

Bad Assignment error in Sycon software

Viewed 1 times since Tue, Nov 28, 2006

When using the sample ladder I get an M0/M1 file reference error in my SLC processor if the MVI46 or 3150 is not in Slot 1.

Viewed 1 times since Tue, Nov 28, 2006

What IEC 60870-5-101S timestamp formats are supported?

Viewed 1 times since Tue, Nov 28, 2006