KB Home \| Advanced Search \| News \| Ask Question
ProSoft Knowledge Base

Are the serial ports isolated on 4xxx or 5xxx Series Gateways

Article Number: 340 | Rating: 1/5 from 1 votes | Last Updated: Mon, Jun 30, 2014 at 3:39 PM

The 4xxx and 5xxx series ProLinx Gateways have opto-isolated application serial ports. The debug/config serial port is not opto-isolated. The opto-isolators used on ProLinx are the HCPL-0531 type from Avago Semiconductor and are UL recognized to withstand 2500 Vrms (input to output) for one minute.

Custom Fields

Attachments (0)

Attachments

There are no attachments for this article.

Comments

Comments

There are no comments for this article. Be the first to post a comment.

Related Articles

Why am I unable to communicate with Wonderware from a 4xxx or 5xxx Series gateway in a full Duplex DF1 configuration

Viewed 1 times since Tue, Nov 28, 2006

Accessing the Debug Port on a 4101 ProLinx module

Viewed 1 times since Tue, Nov 28, 2006

I need to connect multiple DF1 devices to a single serial port on an SLC or MicroLogix processor, is there a solution?

Viewed 1 times since Tue, Nov 28, 2006

How to upload a configuration file from 4xxx or 5xxx Gateway?

Viewed 1 times since Tue, Nov 28, 2006

Debug port connection parameters for Prosoft modules and gateways

Viewed 1 times since Tue, Nov 28, 2006

Which of your products support RS-485 serial protocols?

Viewed 1 times since Wed, Feb 6, 2008

Can I configure my ProLinx 4xxx or 5xxx series gateway via Ethernet?

Viewed 1 times since Tue, Nov 28, 2006

Does the 4102 or 5102-MCM4-DFCM4 module have 4 Modbus ports and 4 DF1 ports (8 ports total)?

Viewed 1 times since Tue, Nov 28, 2006

Why does the session time out when downloading a configuration file via HyperTerminal to my 4xxx or 5xxx Series ProLinx Gateway?

Viewed 1 times since Tue, Nov 28, 2006

What is the function of the "Delay Preset" in the Data Map section?

Viewed 1 times since Tue, Nov 28, 2006