KB Home \| Advanced Search \| News \| Ask Question
ProSoft Knowledge Base

I have a xxxx-xxx-DFCM4 with Pass-Through enabled. The Pass-Through (Debug/CFG) port and the Port 0 DFCM port shows no activity. What am I doing wrong?

Article Number: 135 | Rating: 1/5 from 1 votes | Last Updated: Mon, Jun 30, 2014 at 3:34 PM

When using a ProLinx gateway that supports DF1 pass-through, you will need to enable at least one command on DFCM port 0. If no commands are really needed, than the poll rate on a single command can be set to a high poll rate in order to minimize the impact.

Custom Fields

Attachments (0)

Attachments

There are no attachments for this article.

Comments

Comments

There are no comments for this article. Be the first to post a comment.

Related Articles

IEC-60870-5-104 Server Tutorial

Viewed 1 times since Mon, Sep 3, 2012

Are the serial ports isolated on 4xxx or 5xxx Series Gateways

Viewed 1 times since Mon, Jul 16, 2007

Accessing the Debug Port on a 4101 ProLinx module

Viewed 1 times since Tue, Nov 28, 2006

Does the 4102 or 5102-MCM4-DFCM4 module have 4 Modbus ports and 4 DF1 ports (8 ports total)?

Viewed 1 times since Tue, Nov 28, 2006

Debug port connection parameters for Prosoft modules and gateways

Viewed 1 times since Tue, Nov 28, 2006

Which of your products support RS-485 serial protocols?

Viewed 1 times since Wed, Feb 6, 2008

How do I transfer a floating point value using integer files in a MicroLogix1500?

Viewed 1 times since Thu, Apr 24, 2008

Can I configure my ProLinx 4xxx or 5xxx series gateway via Ethernet?

Viewed 1 times since Tue, Nov 28, 2006

What is the function of the "Delay Preset" in the Data Map section?

Viewed 1 times since Tue, Nov 28, 2006

What are the power requirements for the ProLinx and PLX communication gateways?

Viewed 1 times since Tue, Nov 28, 2006