Home » Categories » Gateways » 4000 / 5000 Series |
Bad Assignment error in Sycon software |
Article Number: 114 | Rating: Unrated | Last Updated: Fri, Jun 27, 2014 at 4:50 PM |
When using Sycon software with a PDPM module, you will see a "bad assignment" in the network view menu. This does not indicate an error with the PDPM module communicating to the slave. Sycon software is a generic PROFIBUS master software that is used in many master applications. The bad assignment error relates to an OPC server functionality within Sycon. This feature of Sycon is not available when using Sycon with a ProLinx PDPM module, but rather is designed for when Sycon is being used with a PCI card that is installed in a PC and then takes that data to an OPC application (not a Prosoft product). The network view menu does not indicate status of your network with the ProLinx module. To view the status of the network with our ProLinx module you will want to do an online->start debug mode.
Related Keywords: PDPM |
Attachments (0)
There are no attachments for this article.
|
Comments
There are no comments for this article. Be the first to post a comment.
|
Why am I unable to communicate with Wonderware from a 4xxx or 5xxx Series gateway in a full Duplex DF1 configuration
Viewed 1 times since Tue, Nov 28, 2006
Can I configure my ProLinx 4xxx or 5xxx series gateway via Ethernet?
Viewed 1 times since Tue, Nov 28, 2006
Which of your products support RS-485 serial protocols?
Viewed 1 times since Wed, Feb 6, 2008
What is the function of the "Delay Preset" in the Data Map section?
Viewed 1 times since Tue, Nov 28, 2006
Why does the session time out when downloading a configuration file via HyperTerminal to my 4xxx or 5xxx Series ProLinx Gateway?
Viewed 1 times since Tue, Nov 28, 2006
How do I get Floating Point (or Double INT or Unsigned INT) data?
Viewed 1 times since Wed, Nov 29, 2006
I have a xxxx-xxx-DFCM4 with Pass-Through enabled. The Pass-Through (Debug/CFG) port and the Port 0 DFCM port shows no activity. What am I doing wrong?
Viewed 1 times since Tue, Nov 28, 2006
How to upload a configuration file from 4xxx or 5xxx Gateway?
Viewed 1 times since Tue, Nov 28, 2006
IEC-60870-5-104 Server Tutorial
Viewed 1 times since Mon, Sep 3, 2012
I need to connect multiple DF1 devices to a single serial port on an SLC or MicroLogix processor, is there a solution?
Viewed 1 times since Tue, Nov 28, 2006
|