KB Home \| Advanced Search \| News \| Ask Question
ProSoft Knowledge Base

I need to connect multiple DF1 devices to a single serial port on an SLC or MicroLogix processor, is there a solution?

Article Number: 20 | Rating: Unrated | Last Updated: Mon, Jun 30, 2014 at 2:49 PM

ProSoft makes a DF1 gateway that functions as a multiplexor. This permits up to 3 DF1 master devices to communicate to a single SLC or MicroLogix processor while only using a single communication port on the processor. Additional information can be found on the products web page:

http://www.prosoft-technology.com/Products/Gateways/DF1-Serial-Port-Expander-Gateway/DF1-Serial-Port-Expander-Gateway

Custom Fields

Attachments (0)

Attachments

There are no attachments for this article.

Comments

Comments

There are no comments for this article. Be the first to post a comment.

Related Articles

Which of your products support RS-485 serial protocols?

Viewed 1 times since Wed, Feb 6, 2008

Why am I unable to communicate with Wonderware from a 4xxx or 5xxx Series gateway in a full Duplex DF1 configuration

Viewed 1 times since Tue, Nov 28, 2006

Are the serial ports isolated on 4xxx or 5xxx Series Gateways

Viewed 1 times since Mon, Jul 16, 2007

Why am I unable to download a configuration file to a 4xxx or 5xxx Series gateway, and the Debug Port LED is on?

Viewed 1 times since Fri, Jun 27, 2014

Accessing the Debug Port on a 4101 ProLinx module

Viewed 1 times since Tue, Nov 28, 2006

Can I configure my ProLinx 4xxx or 5xxx series gateway via Ethernet?

Viewed 1 times since Tue, Nov 28, 2006

Why does the session time out when downloading a configuration file via HyperTerminal to my 4xxx or 5xxx Series ProLinx Gateway?

Viewed 1 times since Tue, Nov 28, 2006

Debug port connection parameters for Prosoft modules and gateways

Viewed 1 times since Tue, Nov 28, 2006

How to upload a configuration file from 4xxx or 5xxx Gateway?

Viewed 1 times since Tue, Nov 28, 2006

I have a xxxx-xxx-DFCM4 with Pass-Through enabled. The Pass-Through (Debug/CFG) port and the Port 0 DFCM port shows no activity. What am I doing wrong?

Viewed 1 times since Tue, Nov 28, 2006