| Home » Categories » Multiple Categories |
Can I configure my ProLinx 4xxx or 5xxx series gateway via Ethernet? |
| Article Number: 94 | Rating: Unrated | Last Updated: Fri, Jun 27, 2014 at 4:44 PM |
|
The only way to configure or debug a 4xxx or 5xxx series ProLinx gateway is through the serial Debug/Config port.
|
Attachments (0)
There are no attachments for this article.
|
Comments
There are no comments for this article. Be the first to post a comment.
|
Prosoft Configuration Builder (PCB) runtime errors: "SideBySide" or VC++ files not found
Viewed 1 times since Mon, Jun 24, 2013
Bad Assignment error in Sycon software
Viewed 1 times since Tue, Nov 28, 2006
How do I transfer a floating point value using integer files in a MicroLogix1500?
Viewed 1 times since Thu, Apr 24, 2008
Why am I unable to download a configuration file to a 4xxx or 5xxx Series gateway, and the Debug Port LED is on?
Viewed 1 times since Fri, Jun 27, 2014
Does ProSoft Configuration Builder run in Windows 7/8/10?
Viewed 1 times since Wed, Jun 25, 2014
Why am I unable to communicate with Wonderware from a 4xxx or 5xxx Series gateway in a full Duplex DF1 configuration
Viewed 1 times since Tue, Nov 28, 2006
I am trying to connect to the Debug/Configuration port using HyperTerminal on Windows Vista. How can I do this?
Viewed 1 times since Thu, Apr 9, 2009
How do I get Floating Point (or Double INT or Unsigned INT) data?
Viewed 1 times since Wed, Nov 29, 2006
Are the serial ports isolated on 4xxx or 5xxx Series Gateways
Viewed 1 times since Mon, Jul 16, 2007
Transferring Module Configuration over a Serial Port
Viewed 1 times since Tue, Jun 16, 2015
|

Add Comment